PAS tie rod/steering arm removal ?

Moderators: scimjim, Lukeyboy46, erikscimitardemon, Roger Pennington, philhoward

User avatar
peter freeman
RSSOC Member
Posts: 10081
Joined: Thu Aug 31, 2006 12:12 pm
Location: Newcastle
Has thanked: 9 times
Been thanked: 380 times

PAS tie rod/steering arm removal ?

Post by peter freeman » Wed Jul 10, 2019 8:56 pm

Nothing to stop you filing a couple of flats on the rod then you can put a spanner on it ( adjustable ) or a pair of mole grips - you can then apply more pressure on the nut. The rod has a big enough diameter to allow for a couple of flats.

Posts: 141
Joined: Sun May 19, 2013 11:06 am
Location: Kingsclere Hants
Has thanked: 5 times
Been thanked: 1 time

PAS tie rod/steering arm removal ?

Post by PlasticMan » Wed Jul 10, 2019 9:39 pm

The two hammer method works a treat, will have to log that in the old memory bank!

Thanks for all the sugestions.

RSSOC Member
Posts: 2232
Joined: Fri Apr 24, 2009 10:11 am
Location: Steeton, Yorkshire Dales
Has thanked: 34 times
Been thanked: 157 times

PAS tie rod/steering arm removal ?

Post by gtcse8 » Wed Jul 10, 2019 10:04 pm

Good result. :D

You should try the bread trick to remove bearings :lol:

Mark Wilson. See the Beast on youtube under" RELIANT SCIMITAR CONVERSION LOL.,Three Se5a, Se6a, Two Se6b`s,1 & 1/2 GTC`s & not a lot of sense
EX SST 1800Ti

Post Reply

Return to “Se6/6a/6b/GTC”