Cam Bearings

Discuss and exchange views and technical information about our cars.

Moderators: scimjim, philhoward, erikscimitardemon, Roger Pennington, Lukeyboy46

Post Reply
weaver
RSSOC Member
Posts: 36
Joined: Mon Oct 12, 2015 7:53 pm
Location: west yorkshire
Has thanked: 8 times
Been thanked: 1 time

Cam Bearings

Post by weaver » Thu Jul 12, 2018 3:46 pm

Hi all, I'm after as much advice as possible. As anyone changed the cam Bearings themselves or should it be left to an expert?
DSC_0616.JPG
DSC_0616.JPG (75.18 KiB) Viewed 208 times



Oldconn
RSSOC Member
Posts: 1471
Joined: Sat Aug 10, 2013 1:09 pm
Location: Haute-Saône,France
Has thanked: 48 times
Been thanked: 76 times

Cam Bearings

Post by Oldconn » Thu Jul 12, 2018 8:46 pm

coincidence! I am just looking at mine, and wondering the same. I think you need a special tool to pull them out & push new ones in; then there's the question of alignment; and then should they be honed to final size, or not? If nobody on here comes up with the definitive answers, I shall take mine to a pro shop .


"When I grow up, I want to be me"
-Kermit Weeks
Current: SE6A; 998 Mini.Previous: Morris Minor,Ford8, Cortinas Mk1 &2,MG Midget 1932,Morgan 3W 1934,Lagonda Rapier,Honda S800, Austin Maxi,Citroen GSA, Riley ElfMk2,Peugeot 505,Rover 420 SDI

efi_sprintgte
RSSOC Member
Posts: 1082
Joined: Fri Oct 22, 2010 6:24 pm
Location: Sutton, Surrey
Has thanked: 74 times
Been thanked: 52 times

Cam Bearings

Post by efi_sprintgte » Thu Jul 12, 2018 9:47 pm

Fittings not too hard, they do however need line boring after so I would have a friendly machinist do it


JC

Post Reply

Return to “General Technical Discussion”