SST pop-up headlamps

Moderators: philhoward, Lukeyboy46, Roger Pennington, erikscimitardemon

Re: SST pop-up headlamps

Postby greeny » Fri May 19, 2017 2:54 pm

peter freeman wrote:Not sure where the relay is but if its the same as the SS1's its at the end of the fuse box. If you are looking for the earth connection to brake the motor I would expect it to be just a link on the relay base. Just swap the relays around as most of them don't use the normally closed contact anyway - if the problem goes away then you know what the cause was.


Iirc it is on the fuse box can't remember which one it is though....
Babe the GTC number 229 and and Smurfett the 1400 SST. Ness the vw t4 van/dayvan/camper
Previous 3.0v6 X type jaguar triumph acclaim scimitar SE4A 663 (ex Collin Watson coupe) 2x se5a's 2x SS1 1600s and a load.of other things I can't remember!!!
GTC drivers doing it under canvas since 1981!!
RSSOC SCIMITAR GTC REGISTRAR
Website scimitargtc.co.uk
12601 14846 18/09/12
User avatar
greeny
RSSOC Member
 
Posts: 5296
Images: 8
Joined: Wed Jun 02, 2010 7:25 pm
Location: Dukinfield Cheshire
Has thanked: 17 times
Been thanked: 118 times

Re: SST pop-up headlamps

Postby peter freeman » Fri May 19, 2017 3:13 pm

I knew I would have some info somewhere.
Attachments
fuse box.jpg
fuse box.jpg (94.75 KiB) Viewed 144 times
User avatar
peter freeman
RSSOC Member
 
Posts: 8418
Joined: Thu Aug 31, 2006 12:12 pm
Location: Newcastle
Has thanked: 14 times
Been thanked: 266 times

Re: SST pop-up headlamps

Postby scimjim » Fri May 19, 2017 10:01 pm

The motor drive relays that provide a brake when the limit switch opens (R5 & R6 on an SS1) are mounted on the armature beside the motors - so I presume there's only one on a monobody (SST/Sabre) and it's either going to be by the motor or possibly on the inner wing. It's definitely not in the fuse/relay box.

As Phil W says at the start of his excellent guide,

Two methods can be adopted to find the root cause of any problems:

• Guesswork and replacement of components until the problem is discovered
• Using a logical method to trace any faults by means of elimination
Jim King

Current: SE5 (8Ball), 1600 SS1 (G97), 2.5TD SE5a (diesel 5a), 6 x random other SS1s.
Previous: SE5, 3 x SE5a, 2 x SE6a, 3 x SE6b, GTC, 2.9i GTC, 3 x 1600 SS1, 1300 SS1, Mk1 Ti Sabre, Mk1.5 CVH Sabre
Chief mechanic for: SE6a (Katrina), 1400EFi SS1 (Grawpy), Sabre/MX5 auto (The Flying Broomstick), 1400 K series SS1 (Megan3), TI SS1 (snotty), 1300 SS1 (Number One) & Sarah's coupe.
CURE THE FAULT - NOT THE SYMPTOMS
User avatar
scimjim
RSSOC Member
 
Posts: 32340
Images: 0
Joined: Sun Oct 01, 2006 10:08 pm
Location: Gloucester
Has thanked: 95 times
Been thanked: 676 times

Re: SST pop-up headlamps

Postby Corky » Sat May 20, 2017 9:24 am

There are some photos and discussion about the SST/Sabre headlamp motor in my project thread here http://www.scimitarweb.co.uk/sgwrs/viewtopic.php?f=20&t=10566&start=1050, which may help.
Steve
Current:- Sabre Ti sprint car, Audi A4 B8 Avant Quattro, SS1 race car project.
Prev:- SS1 Ti, SS1 16v Turbo Racer, 5XGTC, 2XSE6B, 2XSE5A, 2XV6 Coupe, Sabre 6
Project Threads & YouTube

“It's not the winning, it's the taking apart that counts"
User avatar
Corky
RSSOC Member
 
Posts: 9692
Images: 1
Joined: Sun Sep 24, 2006 5:02 am
Location: Macclesfield
Has thanked: 60 times
Been thanked: 82 times

Re: SST pop-up headlamps

Postby Mateybass » Sat May 27, 2017 2:23 am

les wrote:Hello,
when I switch off the headlamps they continue to cycle up and down a few times before staying down.
Is there a simple cure or is this going to be difficult?
Any info. much appreciated, thank you.
Les. In Norfolk.


It can really only be either the limit switches in the lift motor sticking or more likely to be a sticky lift motor relay, which is located near the motor itself. and prone to weather ingress over time. Referring to the circuit diagram, you're looking at M6 or R5... the SST doesn't have M7 or R6. Just swap out the relay, it's a standard fit and should cure your problem.

The only other thing it might be is pull-to-flash contacts too close to each other on the column stalk switch... had that on mine once... if you so much as looked at the dip lever stalk the headlamps popped up and back down. Just increase the gap to eradicate accidental triggering.
1991 Reliant Scimitar SST 1400 number 39 - Skippy's Facebook Page
1999 Subaru Forester S-Turbo Auto (LT)


RSSOC member no. 6883
User avatar
Mateybass
RSSOC Member
 
Posts: 768
Images: 17
Joined: Mon Sep 06, 2010 2:47 am
Location: North Lincolnshire
Has thanked: 2 times
Been thanked: 17 times

Previous

Return to SS1/SST/Sabre

Who is online

Users browsing this forum: No registered users and 4 guests