Gte track rod end thread

Discuss and exchange views and technical information about our cars.

Moderators: scimjim, philhoward, erikscimitardemon, Roger Pennington, Lukeyboy46

Post Reply
User avatar
MikeyBikey
RSSOC Member
Posts: 5469
Joined: Thu Mar 11, 2010 2:55 pm
Location: Sunny Falmouth. :)
Has thanked: 167 times
Been thanked: 87 times

Gte track rod end thread

Post by MikeyBikey » Wed Jun 07, 2017 9:41 pm

Recently purchased a pair of QH track rod ends advertised for a 5a. However upon receipt the thread was much coarser than my steering rack. Thus I cannot use them. Was there more than one thread type used?

Cheers


Is we sideways yet...

ScimmyMike
RSSOC Member
Posts: 4895
Joined: Sun Mar 15, 2009 6:12 pm
Location: Hyde, Cheshire
Has thanked: 14 times
Been thanked: 103 times

Re: Gte track rod end thread

Post by ScimmyMike » Wed Jun 07, 2017 9:52 pm

I've been there, done that, sat in a box in garage, only place to get them sort of things rightare QRG and Walkers it seems


SE4c rebuilding. SE5a similar it seems!
SAAB C900 2 door
Scimitar SE4 SE4c SE5 SE6b Austin A35

High Peak Noggin Secretary & general dogsbody

www.high peak noggin

If you can see the tree before you hit it that's understeer
if you only feel the tree as you hit it that's oversteer

b.c.flat hat
RSSOC Member
Posts: 1937
Joined: Tue Aug 28, 2007 6:29 pm
Location: St. Martins, Oswestry.
Has thanked: 34 times
Been thanked: 74 times

Re: Gte track rod end thread

Post by b.c.flat hat » Wed Jun 07, 2017 10:15 pm

Yerse mate, I've had trouble int' past wi' this. Mine turned out t' be M14 x 2.00mm pitch, Firstline FTR 4040. Some TREs have tapers too small but correct thread! Nightmare! Hope this helps, Crusty.



gtcse8
RSSOC Member
Posts: 1300
Joined: Fri Apr 24, 2009 10:11 am
Location: Steeton, Yorkshire Dales
Has thanked: 11 times
Been thanked: 70 times

Re: Gte track rod end thread

Post by gtcse8 » Wed Jun 07, 2017 11:22 pm

9/16 x 18tpi UNF for se5a.
Firstline FTR 4019, Quinton Hazell QR1153S, Motoquip VSS114.

M14 x 2.00 pitch on se6 onwards.
FIRSTLINE FTR4065, Quinten Hazell QR1556S, Motoquip VSS120.

As crusty says there are quite a few combinations that "Seem" to fit, but you must use the correct combination of Thread and taper, Brian`s turned out to be a Ford fitment, probably from an earlier rebuild as it`s a common misnomer that Scimitars use Ford running gear.


See the Beast on youtube under" RELIANT SCIMITAR CONVERSION LOL.,Se5,Se5a, Se6a, Two Se6b`s, GTC, SST 1800Ti & not a lot of sense

Post Reply

Return to “General Technical Discussion”